Quote:
Originally Posted by Nadine UK GTS
Hi Jack, do you still need this measuring? I have an old OE one in the garage, I could dig out and measure if helps. I can measure accuratly...I've recently done such measurements converting a 10.5" clutch and fork set up on my Cobra over to an internal hydraulic release bearing and 7.25" twin plate clutch!
|
Nadine:
you would have to bolt it down with a the disk installed. I am going measure mine this weekend. This can give us a baseline so that we know what is correct for our cars.
I found something very interesting and bothersome. I had four throwout bearings (from previous clutch changes). I measured the length between the contact surfaces, three measured identical at 2.161 and the fourth was 2.064. That is scary since there is not a great amount of travel to begin with.