Plastic coating behind front wheels.

[vincy]

We expect to get our 2008 in a month or so. We always put clear bras on our cars. Can you put the plastic on the area between the wheel and below the door? Is the heat from the exhaust too high? Thanks

[29OUTLAW]

No problemo

[goldcup]

I can only tell you about GenII,I tried a test piece on mine and it fried it like an egg!!!Good luck on that new car,I think I would stroke out from excitement if I was waiting on An 08 to be delivered!!!

[wallbanger]

i had a piece put behind the front and rear wheels on my 03....no problems whatsoever and i'll do the same when my 08 gets here

[Ken Lally]

Originally Posted by vincy

We expect to get our 2008 in a month or so. We always put clear bras on our cars. Can you put the plastic on the area between the wheel and below the door? Is the heat from the exhaust too high? Thanks

Under the side pipe sills - they get chewed up. Got them on mine.

[redtanrt10]

Vincy, you can go about 1 foot or so behind the wheel well with no problems. It should stop right around the front facing edge of the door.

[SnakeEye]

Get it done right away and protect that paint.

[B767DRIVER]

I have 3M on the complete side sills front to back since day one. No problems. Most of the local guys do the same thing and no problems. I also did the area behind the rear tires.

[PJJP]

where do I get this stuff?

[Newport Viper]

Originally Posted by B767DRIVER

I have 3M on the complete side sills front to back since day one. No problems. Most of the local guys do the same thing and no problems. I also did the area behind the rear tires.

Same here. No problems!

[Andrew/USPWR]

If it goes bad just replace it as needed. I'd do the entire sills on both side.

[B767DRIVER]

Originally Posted by PJJP

where do I get this stuff?

Here is their website. You can search installers there. There are 2 in Plano. Someone in your local club can probably recommend someone. Good luck.

For the Consumer...