reverse engineering stock timing

ceokris

Viper Owner
Joined
Jun 3, 2003
Posts
18
Reaction score
0
Location
Tucson, AZ
Has anyone reverse engineered the timing maps in a GTS? I know what they are approximately at WOT. But how about compared to load?

I'm trying to figure out how much total advance the PCM outputs primarily compared to the input voltage of the MAP sensor with RPMs while still in open loop.

Thanks.
 

Viper Specialty

Legacy/Supporting Vendor
Supporting Vendor
Joined
Feb 14, 2002
Posts
5,710
Reaction score
53
Location
Cape Coral, FL
Has anyone reverse engineered the timing maps in a GTS? I know what they are approximately at WOT. But how about compared to load?

I'm trying to figure out how much total advance the PCM outputs primarily compared to the input voltage of the MAP sensor with RPMs while still in open loop.

Thanks.

Post your PCM Part Number, and I can post the timing maps...
 
OP
OP
C

ceokris

Viper Owner
Joined
Jun 3, 2003
Posts
18
Reaction score
0
Location
Tucson, AZ
P04848702AE

I decided to go with SCT, however it still wouldn't hurt to see how close I can get with the splitsec. Figure there are some people still left out there that could benefit just in case.
 
Top