Radio Bezel Gauges, Any issues with removing gauges for Aftermarket

[Nixon's SRT]

Has anyone removed the factory gauges in the radio bezel? Does it cause any issues with the the OBD or any other issues. I would like to pull out the factory unit and install 4 aftermarket gauges. For a Gen III

 

[treesnake]

Has anyone removed the factory gauges in the radio bezel? Does it cause any issues with the the OBD or any other issues. I would like to pull out the factory unit and install 4 aftermarket gauges. For a Gen III

It is a little more involved than it looks. The 4 factory gauges are all connected. Just takes some time to get alignment right.
I am using an AEM serial gauge on top. Boost, oil and water are Autometer. That's a Raptor shift light where the "pass. air bag" light was..

 

[Nixon's SRT]

Thanks, that is the pic i found

I will be putting a Boost/Vac, Fuel Pressure, Oil Pressure and Coolant Temp.

I would guess that the factory coolant sensor would need to stay in place for the Stock ECU. Can i remove the factory oil pressure sensor and replace with the gauge sensor? Also any location good for the coolant sensor since ill be leaving in the factory one.