How to install a diff in your GEN II

Boosted Motorsports

Enthusiast
Joined
Mar 21, 2017
Posts
23
Reaction score
4
In this video I show how I changed the differential in my Viper to a Mopar Performance 3.73.

Install is pretty straight forward and would be much easier with a lift and power tools but this video shows that it can be done in your own garage.

Check back on YouTube for more videos uploaded every few days! In car review video also coming soon once gears are broken in but so far it is a HUGE upgrade to the car and my most favorite mod yet. ;)

https://youtu.be/l4GzvLueOqs
https://youtu.be/l4GzvLueOqs
 
Last edited:

ViperJohn

Enthusiast
Joined
May 29, 2003
Posts
3,615
Reaction score
2
Location
Maryland
Didn't see any mention of installing a speedo calibration unit. Did you not put one in?
 

lukem80

Enthusiast
Joined
Nov 30, 2016
Posts
11
Reaction score
0
Location
Montgomery AL
how do you remove the half shafts from the spindles? look like it has a cotter pin and an axle nut?
 
OP
OP
B

Boosted Motorsports

Enthusiast
Joined
Mar 21, 2017
Posts
23
Reaction score
4
Didn't see any mention of installing a speedo calibration unit. Did you not put one in?

I have not added one yet! Looking into options for a dedicated cal unit but also heard from Dan Cragen there is a way to alter the PCM to make the change.

how do you remove the half shafts from the spindles? look like it has a cotter pin and an axle nut?

There is another U-Joint at the spindle which I removed rather than mess with the axle nut. I had the spindles and control arms off right before this doing poly urethane bushings on all 4 corners. I'll post up that video as well! :)
 
Top